-
-
Available Formats
- Options
- Availability
- Priced From ( in USD )
-
Available Formats
-
- Immediate download
- $56.00
- Add to Cart
-
- Printed Edition
- Ships in 1-2 business days
- $56.00
- Add to Cart
Customers Who Bought This Also Bought
-
ASTM D1796-22
Priced From $63.00 -
ASTM D1092-20
Priced From $50.00 -
ASTM D975-24a
Priced From $90.00 -
ASTM D1835-22
Priced From $54.00
About This Item
Full Description
1.1 This test method covers the determination of total sulfur in liquid petroleum products in concentrations from 0.01 % to 0.4 % by mass (Note 1). A special sulfate analysis procedure is described in Annex A1 that permits the determination of sulfur in concentrations as low as 5 mg/kg.
Note 1: The comparable lamp method for the determination of sulfur in liquefied petroleum gas is described in Test Method D2784. For the determination of sulfur in heavier petroleum products that cannot be burned in a lamp, see the high pressure decomposition device method (Test Method D129) the quartz tube method (IP 63), or the high-temperature method (Test Method D1552).
1.2 The direct burning procedure (Section 9) is applicable to the analysis of such materials as gasoline, kerosine, naphtha, and other liquids that can be burned completely in a wick lamp. The blending procedure (Section 10) is applicable to the analysis of gas oils and distillate fuel oils, naphthenic acids, alkyl phenols, high sulfur content petroleum products, and many other materials that cannot be burned satisfactorily by the direct burning procedure.
1.3 Phosphorus compounds normally present in commercial gasoline do not interfere. A correction is given for the small amount of acid resulting from the combustion of the lead anti-knock fluids in gasolines. Appreciable concentrations of acid-forming or base-forming elements from other sources interfere when the titration procedure is employed since no correction is provided in these cases.
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Document History
-
ASTM D1266-18
viewing
Standard Test Method for Sulfur in Petroleum Products (Lamp Method)- Most Recent
-
ASTM D1266-13
Standard Test Method for Sulfur in Petroleum Products (Lamp Method)- Historical Version
-
ASTM D1266-07
Standard Test Method for Sulfur in Petroleum Products (Lamp Method)- Historical Version
-
ASTM D1266-98(2003)e1
Standard Test Method for Sulfur in Petroleum Products (Lamp Method)- Historical Version
-
ASTM D1266-98
Standard Test Method for Sulfur in Petroleum Products (Lamp Method)- Historical Version
-
ASTM D1266-91(1995)
Standard Test Method for Sulfur in Petroleum Products (Lamp Method)- Historical Version
-
ASTM D1266-87
Standard Test Method for Sulfur in Petroleum Products (Lamp Method)- Historical Version