-
-
Available Formats
- Availability
- Priced From ( in USD )
-
Available Formats
-
- Immediate download
- $54.00
- Add to Cart
-
- Printed Edition
- Ships in 1-2 business days
- $54.00
- Add to Cart
Customers Who Bought This Also Bought
-
ASTM B874-96(2023)
Priced From $55.00 -
ASTM C538-83(2018)
Priced From $60.00 -
ASTM E194-20
Priced From $46.00 -
ASTM B329-20
Priced From $44.00
About This Item
Full Description
1.1''This guide gives guidance in the selection of sampling plans to be used in the inspection of electrodeposited and related coatings on products for the purpose of deciding whether submitted lots of coated products comply with the specifications applicable to the coatings. This supplements Test Method B602 by giving more information on sampling inspection and by providing additional sampling plans for the user who finds the limited choice of plans in Test Method B602 to be inadequate.
1.2''When using a sampling plan, a relatively small part of the articles in an inspection lot is selected and inspected. Based on the results, a decision is made that the inspection lot either does or does not satisfactorily conform to the specification.
1.3''This guide also contains several sampling plans. The plans are attribute plans, that is, in the application of the plans each inspected article is classified as either conforming or nonconforming to each of the coating requirements. The number of nonconforming articles is compared to a maximum allowable number. The plans are simple and relatively few. Additional plans and more complex plans that cover more situations are given in the Refs (1-7) at the end of this guide and in MIL-STD-105.
1.4''Acceptance sampling plans are used:
1.4.1''When the cost of inspection is high and the consequences of accepting a nonconforming article are not serious.
1.4.2''When 100'''% inspection is fatiguing and boring and, therefore, likely to result in errors. In these cases a sampling plan may provide greater protection than 100'''% inspection.
1.4.3''When inspection requires a destructive test. Here, sampling inspection must be used.
1.5''Another general type of acceptance sampling plan that is not covered in these guidelines is the variables plan in which measured values of characteristics are analyzed by statistical procedures. Such plans, when applicable, can reduce inspection cost and increase quality protection. Information on variables plans is given in Test Method B762, MIL-STD-414, ANSI/ASQC Z1.9-1979, and Refs (1-2).
1.6''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Document History
-
ASTM B697-88(2021)
viewing
Standard Guide for Selection of Sampling Plans for Inspection of Electrodeposited Metallic and Inorganic Coatings- Most Recent
-
ASTM B697-88(2016)
Standard Guide for Selection of Sampling Plans for Inspection of Electrodeposited Metallic and Inorganic Coatings- Historical Version
-
ASTM B697-88(2010)
Standard Guide for Selection of Sampling Plans for Inspection of Electrodeposited Metallic and Inorganic Coatings- Historical Version
-
ASTM B697-88(2005)
Standard Guide for Selection of Sampling Plans for Inspection of Electrodeposited Metallic and Inorganic Coatings- Historical Version
-
ASTM B697-88(1999)
Standard Guide for Selection of Sampling Plans for Inspection of Electrodeposited Metallic and Inorganic Coatings- Historical Version