-
-
Available Formats
- Options
- Availability
- Priced From ( in USD )
-
Available Formats
-
- Immediate download
- $48.00
- Add to Cart
-
- Printed Edition
- Ships in 1-2 business days
- $48.00
- Add to Cart
Customers Who Bought This Also Bought
-
ASTM G119-09(2021)
Priced From $52.00 -
ASTM G91-11(2018)
Priced From $48.00 -
ASTM G170-06(2020)e1
Priced From $58.00 -
ASTM G111-21a
Priced From $54.00
About This Item
Full Description
1.1 This test method covers the determination of material loss by gas-entrained solid particle impingement erosion with jetnozzle type erosion equipment. This test method may be used in the laboratory to measure the solid particle erosion of different materials and has been used as a screening test for ranking solid particle erosion rates of materials in simulated service environments (1, 2).2 Actual erosion service involves particle sizes, velocities, attack angles, environments, and so forth, that will vary over a wide range (3-5). Hence, any single laboratory test may not be sufficient to evaluate expected service performance. This test method describes one well characterized procedure for solid particle impingement erosion measurement for which interlaboratory test results are available.
1.2 Units-The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard (exceptions below).
1.2.1 Exceptions: Table 1 uses HRB hardness. Footnote 7 and 11.2 use abrasive grit designations.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Document History
-
ASTM G76-18
viewing
Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets- Most Recent
-
ASTM G76-13
Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets- Historical Version
-
ASTM G76-07
Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets- Historical Version
-
ASTM G76-05
Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets- Historical Version
-
ASTM G76-04
Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets- Historical Version
-
ASTM G76-02
Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets- Historical Version
-
ASTM G76-95(2000)
Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets- Historical Version
-
ASTM G76-95
Standard Test Method for Conducting Erosion Tests by Solid Particle Impingement Using Gas Jets- Historical Version