DANSK DSF/ISO/FDIS 21307 [ Draft ]

This International Standard establishes general principles regarding the procedure used in the construction and quality assessment of butt fusion jointing of polyethylene (PE) piping system components specified in accordance with relevant ISO standards. These components are installed in accordance with the relevant codes of practice, national regulations or industry guidance. Specifically, this International Standard specifies three butt fusion jointing procedures for PE pipes and fittings. These are: <br />— single low-pressure fusion jointing procedure; <br />— dual low-pressure fusion jointing procedure; <br />— single high-pressure fusion jointing procedure. This International Standard takes into consideration the materials and components used, the fusion jointing procedure and equipment and the quality assessment of the completed joint. It may be applied in conjunction with appropriate national regulations and standards. NOTE 1 – The references for these procedures are given in the bibliography[1][2][3][4]. Single low-pressure fusion jointing procedure is derived from multiple procedures and agreed by experts, given in the bibliography [1][2]. NOTE 2 – The three procedures detailed in this standard are based on those most commonly used. It is not the intention that one or more of these procedures should be used to replace well established and verified industry based procedures.