-
-
Available Formats
- Availability
- Priced From ( in USD )
-
Available Formats
-
- Immediate download
- $103.34
- Add to Cart
-
- Printed Edition
- Ships in 1-2 business days
- $103.34
- Add to Cart
Customers Who Bought This Also Bought
-
DANSK DS/EN 14037-5
Priced From $78.76 -
DANSK DS/EN ISO 17225-6
Priced From $66.66 -
DANSK DS/IEC TR 62271-307
Priced From $107.52 -
DANSK DS/EN 62637-1
Priced From $84.53
About This Item
Full Description
This document specifies two procedures for the determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastic materials under specified conditions of temperature and load. Procedure A is a mass-measurement method. Procedure B is a displacement-measurement method. Normally, the test conditions for measurement of melt flow rate are specified in the material standard with a reference to this document. The test conditions normally used for thermoplastics are listed in Annex A. The MVR is particularly useful when comparing materials of different filler content and when comparing filled with unfilled thermoplastics. The MFR can be determined from MVR measurements, or vice versa, provided the melt density at the test temperature is known. This document is also possibly applicable to thermoplastics for which the rheological behaviour is affected during the measurement by phenomena such as hydrolysis (chain scission), condensation and cross-linking, but only if the effect is limited in extent and only if the repeatability and reproducibility are within an acceptable range. For materials which show significantly affected rheological behaviour during testing, this document is not appropriate. In such cases, ISO 1133-2 applies. NOTE – The rates of shear in these methods are much smaller than those used under normal conditions of processing, and therefore it is possible that data obtained by these methods for various thermoplastics will not always correlate with their behaviour during processing. Both methods are used primarily in quality control.
Document History
-
DANSK DSF/PREN ISO 1133-1
Plastics – Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics – Part 1: Standard method (ISO/FDIS 1133-1:2022)- Historical Version
-
DANSK DS/EN ISO 1133-1
viewing
Plastics – Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics – Part 1: Standard method (ISO 1133-1:2022)- Most Recent
-
DANSK DS/EN ISO 1133-1
Plastics – Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics – Part 1: Standard method- Historical Version