ASTM D8237-21

1.1''This test method provides a procedure for determining a fatigue curve that is developed using three or more strain levels. The resulting data can be used in the fatigue models for mechanistic-empirical pavement design (that is, Pavement ME). Failure points are determined for estimating the fatigue life of 380'''mm long by 50'''mm thick by 63'''mm in breadth (width) asphalt mixture beam (rectangular prism) specimens sawed from laboratory or field-compacted asphalt mixture, which are subjected to repeated flexural bending.

1.2''The largest nominal maximum aggregate size (NMAS) recommended for beams 50'''mm thick is 19'''mm. Beams made with an NMAS greater than 19'''mm might significantly interfere with the material response, thereby affecting the repeatability of the test.

1.3''The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.4''Units'''The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard, with the exception of degrees ('') where angle is specified in accordance with IEEE/ASTM SI 10.

1.5''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.