ETSI TS 100 607-1

SUBJECT DISC / UA exchange in test 26.5.5.2.3 Attempt counter reset Section 26.11.5.1 - expected sequence shows late rather than ea rly assignment Timing requirement in section 26.7.4.3.2.3 step 88 Tolerances of timing advance Accidental possible expiry of T3240: especially in 26.6.8.4 and 26.6.4 . Progress indicator in 26.5.7.3 Channel Mode IE needed to assign an appropriate channel 26.6.4.1 - Timing requirements after ASSIGNMENT COMMAND Section 26.6.11.1 Classmark Change Procedure Introduction of section 34.2.9 ?Multiple SMS mobile originated? Incorrect delays in 26.2.4 procedure 6 Errors in the Multiband default message contents Section 26.11.3.1.1 - Location updating / accepted - delete expected s equence step 8) SIM/ME Interface: 3V/5V Switching SIM simulator functional requirements - voltage measurement uncertaint y in connection with current spikes SIM/ME Interface: Transmission Speed Enhancement Fixed Number Dialling Clarification of action on expiry of T3210 in 26.7.4.3.2 and 26.7.4.3. 3 Timing requirements in 20.10 and 20.15 Ambient Noise Rejection Section 13.4 - Bandwidth of reference measurements Section 13.4 Table 13-7, DCS1800 values for offests >= 6000 kHz Section 21.3 - Superfluous steps g) and h), and editorials Sections 32.11.5 and 32.12.5 - time difference Dt in requirement 2) Section 20.3 - wait time in step i) Correction on tests with Modem Type V.21 Enhanced Full rate Signalling/ structured procedures/MS originated cal l/ late assignment 26.7.4.3.1 - Clarification, and correction to make old cell available in due time MS residual output power between active bursts Enhanced Full rate Signalling/ structured procedures/MS terminated cal l/ early assignment Coding of the bearer capability IE wheu Enhanced Full rate is supporte d EFR CR for sections 0 to 10 EFR CR to 26.9 EFR phase 2 CR to 26.10 EFR CR for section 26.6 DISC/UA exchange in Test 26.7.4.3.3 Enhanced Full rate Signalling/ emergency call