This specification describes the functional requirements for a sheet form material (either flexible, soft, rigid and/or combination of both) used inside the vehicle door as a means to block the intrusion of water, air, dust and/or noise into the passenger compartment. The intrusion levels of water, air, dust and/or noise will be specified by the Statement of Requirements (SOR) listed for each program. The material assemblies, meeting the requirements of this specification, must function in continuous operating temperatures from -30 °C to 80 °C with expected intermittent exposure to automotive industry paint repair cycles. These materials will not stain fabric surfaces. The three families of material constructions described herein are normally supplied with an adhesive on one side and a release surface on the opposite side so that they may be stacked for shipping. They may be flat or formed to fit the shape of door components as required by the Vehicle Program Component Technical Specification (CTS) and SOR.

Material Description.

Materials conforming to this specification may be supplied to the assembly plant and applied to the door on the assembly line as one of the types listed in 1.1.3.

All types of door sealing systems must be adhered to the door sheet metal with an adhesive which meets or surpasses the requirements outlined in 3.1.3.6.

Material Identification. Reference G.M. Best Practice No. 115434. (The supplier shall work with the GM Design Responsible Engineer to comprehend this requirement.)

Family 1 Materials, (For Level A and B Vehicles).

• Barrier material shall consist of Ethylene Vinyl Acetate, (EVA).

• EVA material shall have density of 1.465kg/m² ± 0.007 kg/m².

• Thickness of EVA barrier must be 1.00 mm ± 0.02 mm.

• Barrier material shall be adhered to door sheet metal with non-gassed hot melt adhesive that meets requirements in Table 1.

Family 2 Materials, (For Level C, D, E and F Vehicles).

• Barrier material shall consist of Polypropylene or Polyethylene (PE) Film.

• Polypropylene or Polyethylene barrier materials shall have density of 0.120 kg/m² ± 0.006 kg/m².

• Thickness of polypropylene of polyethylene barrier materials to be from 0.15 mm to 0.25 mm.

• Barrier material shall be adhered to door sheet metal by a spray adhesive that meets requirements in Table 1.

Materials (For Level C, D, E and F Vehicles).

• Barrier material shall consist of a polyethylene foam sheet.

• Polyethylene foam material shall have a density of 0.440 kg/m² ± 0.022 kg/m².

• Thickness of Polyethylene foam shall be 0.6 mm.

• Barrier material shall be adhered to door sheet metal with non-gassed hot melt adhesive that meets requirements in Table 1.

Data generated for level A through F vehicles are acoustic performance standards generated from US Vehicle Market Segmentation Card.

Symbols. Not applicable.

Typical Applications. Door Noise Barrier Water Deflectors.

Remarks.

Changes in part composition or construction must be approved by the GM Release Engineer and GM Materials Engineer. Any deviation from GM Best Practice No.115434 shall be approved by the Global Subsystem Leadership Team (GSSLT).

The data obtained by these methods are applicable to the material under conditions of the particular test and are not necessarily the same as those obtained in the vehicle. Data obtained may also be used for statistical process control to measure the effectiveness of the production system.